Restore Factory Default Settings

Restore Factory Default Settings

To restore factory default settings:

  1. Turn off your Blackjack 2
  2. Press the Up button on the D-pad
  3. While holding the Up button on the D-pad, turn the Blackjack 2 back on
  4. You should immediately see instructions on how to restore your phone to factory settings

Note: if you see the at&t and 3g animations, try again – most likely you were not pressing the Up button on the D-pad when you turned the phone back on.

8 Responses to “Restore Factory Default Settings”

  1. danios_rlz Says:
    May 22nd, 2009 at 8:28 pm

    Thanks for this post!!!! :)

    THIS LITTLE TIP IS ALSO GREAT FOR FIXING BOOT UP PROBLEMS WITH YOU BJ 2.
    My phone wasn’t booting up completely and everytime I tried, it would get stuck at the
    “WINDOWS MOBILE” splash screen.I tried alot of things:

    1. I tried syncing it with my pc to flash it and that wouldn’t work.
    2. I turned it on in download mode and that still wouldn’t work.
    3. I tried pulling it apart…..of course trhat didnt work either.
    4. I even brought it to a ‘techinician’ and that didn’t work either.

    FINALLY!!!!!!! A SOLUTION!!!!!

    :) ALL I HAD TO DO IS RESTORE THE FACTORY DEFAULT SETTINGS:)
    I DID IT ABOUT THREE(3x) TIMES AND THEN JUST LEAVE IT ON AND IT WILL EVENTUALLY MOVE FROM THE
    WINDOWS MOBILE SCREEN AND BOT NORMALLY.

    THANKS ALOT MAN!!!1

  2. Peter Says:
    April 10th, 2010 at 6:58 am

    This works, Thanx alot man..U Rock…Good Looks

  3. Anonymous Says:
    April 15th, 2010 at 9:40 pm

    thanks

  4. big boy Says:
    June 22nd, 2010 at 7:39 pm

    it work thanx g

  5. Eli Says:
    June 29th, 2010 at 5:12 pm

    Awesome.. thanks

  6. sarai Says:
    July 9th, 2010 at 4:48 pm

    como es?

  7. Anonymous Says:
    July 15th, 2010 at 10:23 am

    thanks dude.. Youre a saviour..

  8. Anonymous Says:
    July 23rd, 2010 at 10:17 pm

    How do i change my scroll settings. while using the d-pad to go around and around it use to go through all itoms left to right now it only goes through two going up and down how do i change this as i dont know how it changed in the first place.

    hope you can help

    cheers

Leave a Reply